Asphalt's Prints
4 posters
Page 1 of 2
Page 1 of 2 • 1, 2
Asphalt's Prints
Here is my first print. I downloaded the file from Thingiverse and converted it using Germinate. It took well over 8 hours to complete, because I made the mistake of putting it on 50% fill.
Re: Asphalt's Prints
Warhammer 40K titan scale Monolith.
It had a little line drooping on the completely horizontal outcroppings, but the interior tapers are perfection.
It had a little line drooping on the completely horizontal outcroppings, but the interior tapers are perfection.
Re: Asphalt's Prints
My first piece with a pass through. The central part of a replica from Stargate SG1
Re: Asphalt's Prints
Here is my first attempt at running a print with "full support."
As you can see in the third pic, it has serious undercuts and hanging hemispheres, so I didn't think there was any chance it would print otherwise.
As you can see in the third pic, it has serious undercuts and hanging hemispheres, so I didn't think there was any chance it would print otherwise.
Re: Asphalt's Prints
Looking really good! What brand of filament are you using?
ModernGnome- Posts : 83
Join date : 2015-10-16
Re: Asphalt's Prints
Unknown, it is a generic filament I bought off of Amazon a while back when I wanted to use a 3D printing pen. The pen sucked, but the filament is quite nice. I will look through my purchase history and see if I can find it.
Re: Asphalt's Prints
ModernGnome wrote:Looking really good! What brand of filament are you using?
No brand name on the filament, but I purchased it from this Amazon Storefront.
http://www.amazon.com/s?marketplaceID=ATVPDKIKX0DER&me=A2HR7GF1C2A1JR&merchant=A2HR7GF1C2A1JR&redirect=true
Re: Asphalt's Prints
My first print completed with putting more than one model on the plate. Thank you administrative privilege button.
Page 1 of 2 • 1, 2
Page 1 of 2
Permissions in this forum:
You cannot reply to topics in this forum
|
|