Filament guide mod

View previous topic View next topic Go down

Filament guide mod

Post by Asphalt on Sat Oct 10, 2015 5:34 pm

I found my filament getting caught on the rougher edges of the guide piece so I used a small paperclip to hold the plastic tube.
[You must be registered and logged in to see this image.]

Asphalt
Admin

Posts : 156
Join date : 2015-10-10

View user profile http://rootprinting.forumotion.com

Back to top Go down

Re: Filament guide mod

Post by ModernGnome on Sun Oct 18, 2015 10:47 pm

I like the simplicity of your design! It makes the one I'm using -- shown here with a bit of sponge I'm using to test filament cleaning and lubrication -- look like overkill.
It's available at [You must be registered and logged in to see this link.][You must be registered and logged in to see this image.]

ModernGnome

Posts : 83
Join date : 2015-10-16

View user profile

Back to top Go down

View previous topic View next topic Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum